MaxTronic Orion 410ST User Manual download pdf (Page 95)

Appendix

Orion 410ST FTP Setting Guide

If only one fixed public IP is available and the Orion 410ST is located behind the NAT, you

will need to set up a passive IP address and port.

1 First, check the ‘Manually Passive IP address and

port’ box to enable them.

2 Then enter a passive IP address by the only one

fixed public IP address available.

The Orion 410ST uses a passive port range of 30000-

50000 as default. Under normal circumstances, there is

no need to change this unless the range is being used for

other purposes. Please see the graphic below for

detailed information.

IP sharing unit setup (Broadband Router)

The Orion 410ST supports FTP usage when only one fixed public IP is available (as

described earlier). The IP sharing unit (broadband router) will need to be set up correctly to

work with this feature.

There are various IP sharing units (broadband routers) provided in the market and we are

unable to go through each of them. The key factor to choose an IP sharing unit is to

make sure it can set up a user-defined virtual server with all ports as well as a

configurable port range.

The IP sharing unit (broadband router) will need to add four virtual servers:

1 NAS_FTP

2 NAS_AFP

3 NAS_WEB

4 Passive_FTP_Data

IP sharing unit (Broadband Router)

D-link DI704up

Connect the DI704up with the default IP address. This is usu-

ally 192.168.0.1. Please note that this IP will vary from

model to model.

Under the advanced tab, add the 4 virtual servers. Follow the

steps below.

1 2 ... 90 91 92 93 94 95 96 97 98 99 100

No comments

MaxTronic Orion 410ST User Manual Page 95